Anti-Walk Pins – Perfect for Drop-In Trigger Assemblies
These stainless steel pins are threaded for set screws on both sides, preventing wear to the trigger pin holes in your lower (important for SBRs and other valuable lowers), and retaining drop-in triggers that may have loose tolerances.
Features
The torque spec on the screw is 11 inch-pounds maximum; 8 inch-pounds of torque are recommended.
Pin Diameter: .154″
Note: The external width of AR receivers varies in the trigger/hammer pin area, depending on the manufacturer. If the pins are too long for your receiver, you may shorten the pins a small amount by carefully filing material evenly from both ends of the pins. However, this is not required. Longer pins will not affect the function or performance of the rifle.























